MagicPlot Manual

Plotting and nonlinear fitting software

User Tools

Site Tools


spline

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
spline [Fri Feb 25 14:32:09 2011]
Alexander
spline [Mon Jun 3 16:47:16 2013]
Alexander
Line 13: Line 13:
 Set ''Baseline'' checkbox in spline row in fit curves table to subtract spline from data. Set ''Baseline'' checkbox in spline row in fit curves table to subtract spline from data.
  
-{{:spline1.png|Using spline for baseline fitting}}+{{:spline1.png?nolink|Using spline for baseline fitting}}
  
 ===== Fitting with Spline ===== ===== Fitting with Spline =====
Line 21: Line 21:
 It is recommended to set appropriate fit intervals which contain only baseline without peaks. In such case ''Fit One Curve'' button is more acceptable than ''Fit by Sum'' button, because the individual interval for current curve will be used and the interval from ''Fit Interval'' tab (which is used to fit by sum of curves) is ignored. Select spline curve and set ''Edit Interval'' checkbox in the bottom of the panel to edit spline interval, then click on ''Fit One Curve'' button. The anchor point coordinates will be varied but the number of points will remain. You also can lock some parameters (usually //x// coordinates) by setting ''Lock'' checkboxes in parameters table.  It is recommended to set appropriate fit intervals which contain only baseline without peaks. In such case ''Fit One Curve'' button is more acceptable than ''Fit by Sum'' button, because the individual interval for current curve will be used and the interval from ''Fit Interval'' tab (which is used to fit by sum of curves) is ignored. Select spline curve and set ''Edit Interval'' checkbox in the bottom of the panel to edit spline interval, then click on ''Fit One Curve'' button. The anchor point coordinates will be varied but the number of points will remain. You also can lock some parameters (usually //x// coordinates) by setting ''Lock'' checkboxes in parameters table. 
  
-{{:spline2.png|Setting Fit Interval for spline curve}} {{:spline3.png|Spline subtraction result}}+{{:spline2.png?nolink|Setting Fit Interval for spline curve}} {{:spline3.png?nolink|Spline subtraction result}}
  
 ===== See Also ===== ===== See Also =====
spline.txt ยท Last modified: Thu Jan 14 17:12:42 2021 by Alexander